In this article, you will know about the Washing Machine Cleaning Guide in detail. So, if you want to know about it, then keep reading this article.
What good is a filthy washing machine? You are correct; it is NOT good! You want your clothes to be cleaned clean, not tossed about and picking up all the mould and grime that has been hiding in your washer for who knows how long. Apart from mould and grime, rusting is a huge issue for washers; it not only eats away at the machine, ultimately destroying it, but it also leaves rust stains on your clean clothing.
Many people find it difficult to understand that a washing machine can get unclean in the first place since it is thoroughly cleaned after each load of laundry. However, here are the facts.
Washers feature a lot of rubber and sealing to eliminate seepages (especially with front loaders), which allows moisture to gather. This moisture causes the growth of mould and mildew, which not only distributes germs onto your clothes but also emits a nasty odor. Furthermore, dirt and germs from your clothing may accumulate in the rubber and hidden crevices of your washer.
So, what do you do when your washer fails to clean your laundry? Instead, use this washing machine cleaning instructions to thoroughly clean your washer and restore that fresh, squeaky clean clothes.
Washing Machine Cleaning Guide Steps
Step 1: Hand-clean the rubbers and seals
Although there are liquid cleaners designed specifically for cleaning washers on the market, a mix of bleach and water cleans just as well and is far less expensive. Make a solution of one part bleach and ten parts water with a few clean, dry cloths. You may either spray this solution or just dip the cloth in it. Begin by cleaning the rubber and seals as far as your hand will allow. If you notice a slimy, mildewed stuff on the inner side of the rubber, use more than one cloth to clean it. When the rags no longer show traces of dirt, go on to the following stage.
Step 2: Set the machine to self-clean.
To get the washer squeaky clean, the basin must be thoroughly cleaned, and the rubber and seals must be thoroughly rinsed after being wiped clear of mould. To do this, put one cup of bleach in the washer (or detergent compartment if you have one), and run the machine on the longest hot water cycle possible. You may either sit back and relax while your washer cleans itself, or you can perform some additional cleaning in the interim, such as these 10 Essential Spring Cleaning Tips. When your machine’s self-cleaning cycle is finished, look for a strong bleach odor. If the stench is too strong or overpowering, run one or two more empty cycles with plain hot water until you’re happy.
Step 3: Clean Exteriors Are Important As Well
It’s also a good idea to clean the outside of your washer for hygiene reasons. Using a clean, moist cloth, wipe any detergent stains and dust from around the knobs. Check the rear of your washer (where the water hoses or pipes are attached) for mildew, dirt, and other microorganisms. The rear of the washing machine should be cleaned every few months, while the interior and outside may be cleaned once a month (or as needed).
Important Washing Machine Maintenance Recommendations:
- Purchase an anti-rust spray. Rust is the most damaging element to your washer. If you notice rust, scrapes, or scratches on the machine, cover them with touch-up paint and spray the area with anti-rust after it has dried overnight.
- Check the hoses on your equipment on a regular basis. If you see any fractures or wear on the hoses, repair them right once to prevent a hose rupture and flooding of the room. Keep in mind that stainless steel hoses are much more robust and trustworthy, so they’re well worth the additional money.
- Never overload your washing machine. Check the user handbook to make sure you’re putting in the correct quantity of laundry every cycle. Overloading might cause the equipment to malfunction and cause additional issues.
- If your washing machine vibrates excessively while in operation, the cause might be uneven flooring. Always check that the washer is entirely level, since this might also create problems with the machine’s performance.
- After each wash, leave the door or lid of the washer slightly open to enable it to air out and dry properly. It will most likely take an hour or more, but it will help prevent mould build-up within the machine.
Also Read
How You Can Clean Hardwood Floors Yourself